flatcam

Open full view…

Double-sided with only two drill holes

parkyjimbo
Mon, 30 Jan 2017 10:01:23 GMT

Just a thought could you not just use two drill alignment holes either side of the PCB along the mirror axis line , then when you flip the board over it just uses these same two holes , job done? The way it is done at the moment seems to complicate the job of double sided PCBs. By the way it is a great tool. -Jim

jpcaram
Thu, 09 Feb 2017 03:52:49 GMT

Of course you can use just two alignment holes! The manual shows 4, but nothing stops you from using just 2. JP