flatcam

Open full view…

Problem with cncjob_coordinate_format

sergio12
Wed, 04 Jan 2017 21:34:13 GMT

I changed the G-Code format to 3 following decimals as it was mentioned in the docs with the shell command, because my controller won't take 4 decimals. So I did it for x and y values and it worked. But when I do this with the shell command for the z value (have not found it in the docs) Flatcam gets screwed up and won't let me generate any plots or G-Codes anymore. How can I set the 3 decimals for Z values properly and fix my Flatcam settings?